Parameters for Operators allow to restrict the values that can be used in the settings of an operation applying this operator.
Task | Actions |
|
|
---|---|---|---|
Prepare in TIS Editor |
|
|
|
Select the operation |
|
|
|
Select which setting should used | E.g. we would like to change Scaling |
|
|
Select the values allowed and pick one | On the right hand side all possible values are shown. Those marked are shown in field of the defined value. The selected value serves as default value. |
|
|
Add the Parameter and bind it to a specific operator used in a node | Add the Parameter to the list of Parameters by pressing the "Add Parameter" button below: NOTE: The parameter is bound to an operator applied to a data node, that is, an operation. However, in the configuration interface, an operator and a data node are defined, regardless of how many times this operator is used in the data node. In practice, an operator is only applied once in a data node, so this problem will hardly show up. When the operator is applied more than once, than the behavior of this parameter is not defined. |
|
|
How to remove a binding of an Parameter to an operation | Go to the place where the binding was made and delete the binding. |
|
|
Operators that can be addressed | |||
Note | For some operators, e.g. Min/Max, you can specify the range of values that can be entered by users. |
|
|